As an Amazon Associate, 456 AutoFix earns from qualifying purchases. Product links below go to Amazon, where you can confirm the right part for your vehicle.
When the front of a Ford Edge starts to float over expansion joints and thump into potholes, the first parts quote usually brings up a choice between the factory brand and a familiar aftermarket name. That is the heart of the monroe vs motorcraft struts question: is the Ford-branded part worth chasing, or does Monroe do the same job with fewer hoops to jump through?
To keep this fair, every part below is a front strut for the 2011-2014 Ford Edge, the refreshed first-generation model that shares its front end with the Lincoln MKX. If you drive something else, our guide to shocks and struts for daily drivers covers a much wider spread of cars and SUVs.
Quick answer
Should a 2011-2014 Ford Edge get Monroe or Motorcraft front struts?
Choose Motorcraft if you want the Ford-branded bare strut and can match its part number to your old one. Choose the Monroe OESpectrum if you want a bare strut with published design details and a lifetime defect warranty. Choose Monroe’s Quick-Strut if you would rather skip the spring compressor entirely.
Our Quick Picks
One bare front strut from each brand for the same 2011-2014 Ford Edge, plus Monroe's Quick-Strut 372889 as the closely related bolt-in option. All three are covered in full below.

Motorcraft AST-913
The Ford-branded strut for owners who match part numbers.

Monroe OESpectrum 72889
Monroe's direct bare-strut rival with its design spelled out.

Monroe Quick-Strut 372889
A complete corner that skips the spring compressor.
Factory Brand Versus Aftermarket Maker
Motorcraft is the parts label Ford sells through its dealers and parts counters, so a Motorcraft strut is the brand’s own idea of what belongs on the car. A trade report on the Motorcraft loaded strut line from Modern Tire Dealer says those assemblies use 98% original equipment components and application-specific valving. That report covers Ford’s loaded units, not the bare AST strut reviewed here, but it shows how Ford positions the brand.
Monroe comes at the same corner from the other direction. It is an independent replacement brand that builds struts for a long list of makes, and it tunes each OESpectrum part to the vehicle it is sold for. Monroe prints a lot more about the inside of its struts than Motorcraft does on Amazon, which helps when you are comparing on paper.
Neither label guarantees a better ride by itself. A strut is a valve, a piston, a rod and a seal in a tube, and how well it works on your Edge depends on the tuning for that model and how well it is installed. The choice really comes down to how each part is sold, documented and backed.
Bare strut or complete assembly
A bare strut is just the damper body. To fit one, the old assembly comes off the Edge, the coil spring is compressed, and the spring, seat, bearing and top mount are moved over to the new strut. That saves money on parts but leaves you reusing a mount that has covered the same miles as the strut it sat on.
A complete assembly, which Monroe sells as the Quick-Strut, arrives with a new spring and upper mount already built up. The swap becomes unbolt and bolt in, with no spring compressor involved. Both Motorcraft and Monroe sell their bare struts in single units, so either way you are buying one corner at a time and should order a matching pair.
Monroe vs Motorcraft Struts: Three Edge Front Parts Up Close
The first two are bare front struts from each brand, and the third is the loaded option for owners who do not want to handle springs. None of the three is sold as a pair, so plan on two boxes, and check Amazon’s fit tool with your year, engine and drive type before you order.
Motorcraft AST-913: Ford-Branded Bare Front Strut for 2011-2014 Ford Edge

- Genuine Motorcraft front strut, part number AST-913
- Vehicle-specific fit, country of origin United States
- Catalogued for select 2009-2014 Edge and 2011-2015 MKX
- Bare strut: reuse or replace spring, seat and mount
The AST-913 is a Motorcraft front strut, which means it carries the brand Ford uses for its own replacement parts. It is a bare strut, so it arrives without a coil spring, spring seat or top mount. The Amazon listing gives the part number, a vehicle-specific fit type and a United States country of origin, but it does not print a vehicle list and asks buyers to contact the seller for fitment.
Retailer catalogs we checked tie AST-913 to select 2009-2014 Ford Edge and 2011-2015 Lincoln MKX models, with notes that vary by engine. None of them stated a side, so compare the number with the strut you are removing or have a Ford parts counter check it against your VIN. Ford sometimes supersedes numbers, and a dealer lookup will show the current one.
This part suits Edge owners who want the Ford-branded strut and already plan to move their spring and mount across with a proper compressor. It also makes sense if the mounts were replaced recently and are still quiet. It is a weaker match if you want printed specs or a stated warranty, since the listing gives neither.
View Motorcraft AST-913 on Amazon

Monroe OESpectrum 72889: Bare Front Strut with Rod Displaced Valving for 2007-2014 Ford Edge

- Listed for 2007-2014 Ford Edge and 2007-2015 Lincoln MKX
- Twin Technology Active Control System for less NVH
- PTFE-banded piston and nitrogen gas charge
- Limited Lifetime Warranty, boot and bumper sold separately
The 72889 is a bare OESpectrum front strut, Monroe’s direct answer to the Motorcraft part above. Its listing names the 2007-2014 Ford Edge and 2007-2015 Lincoln MKX, which covers the 2011-2014 models in this comparison. Monroe also sells a 72888 with the same vehicle list, and the two cover opposite sides, so check each listing’s fit notes and order the pair your Edge needs.
Monroe describes the inside in more detail than most listings. It names a Twin Technology Active Control System to soak up impact harshness, rod displaced valving tuned to the vehicle, and an all-weather fluid meant to resist breakdown in heat and cold. A PTFE-banded piston, nitrogen gas charge, chrome-plated piston and bronze rod guide bearing round out the list.
This strut suits owners with good springs and mounts who want a bare part with its design and coverage in writing. Monroe backs it with a Limited Lifetime Warranty and a Feel the Difference Guarantee, both of which are worth reading before you file a claim. The protective boot and jounce bumper are sold separately, so inspect yours and add new ones if they are torn or crumbling.
View Monroe OESpectrum 72889 on Amazon
Monroe Quick-Strut 372889: Front Strut, Coil Spring and Mount Assembly for 2011-2014 Ford Edge

- Fully assembled strut, coil spring and upper mount
- Listed for 2011-2014 Ford Edge and 2011-2015 Lincoln MKX
- No spring compressor needed for the swap
- Protective coating with salt spray testing
The 372889 is a Monroe Quick-Strut, a complete front corner with the strut, coil spring and upper mount already assembled. Its listing names the 2011-2014 Ford Edge and 2011-2015 Lincoln MKX, the same window used throughout this comparison. It is sold one at a time, so order the matching side as well and read any notes on Amazon’s confirmed fit bar before you buy.
It earns a place here because it removes the riskiest step of a bare strut job. Monroe says the coil spring is calibrated to the original design to restore ride height and carry the vehicle’s weight. The listing also points to a premium upper mount that is meant to cut noise, vibration and memory steer, plus a protective coating that is salt spray tested.
This assembly suits Edge owners whose mounts are noisy or whose springs have sagged, and anyone without a safe way to compress a spring. Replacing the whole corner at once also means the rubber and bearing parts start fresh. It is less useful if your mounts are nearly new, and the Edge still needs an alignment after fitting.
View Monroe Quick-Strut 372889 on Amazon

How the Two Bare Struts Line Up
For the monroe vs motorcraft struts decision on a bare part, the table sticks to what each Amazon US listing and the catalogs we checked actually say. Where a listing is silent, the cell says so rather than guessing on its behalf.
| Point | Motorcraft AST-913 | Monroe OESpectrum 72889 |
|---|---|---|
| Type | Bare front strut | Bare front strut |
| Edge years | Retailer catalogs show select 2009-2014 Edge and 2011-2015 MKX | Listing names 2007-2014 Edge and 2007-2015 MKX |
| Design details printed | Part number, vehicle specific, made in the United States | Twin Technology, rod displaced valving, PTFE-banded piston, nitrogen charge |
| Boot and bumper | Not stated | Sold separately |
| Warranty in listing | Not stated, ask the seller | Limited Lifetime Warranty |
The gap is mostly in paperwork. Monroe tells you what is inside and what the warranty covers, while the Motorcraft listing leaves fitment and coverage to the seller, so you lean on the part number and Ford’s catalog instead.

If you want to see Monroe matched against other brands on different vehicles, our Monroe and Detroit Axle comparison on the Explorer and the Monroe and Gabriel matchup on an Odyssey follow the same one-vehicle approach.
Which Edge Owner Fits Which Part
In most monroe vs motorcraft struts decisions, the right pick has more to do with how you plan to do the job than with the name on the box. Use the table as a starting point, then confirm the part number for your own vehicle.
| Your situation | Closer match | Reason |
|---|---|---|
| You want the Ford-branded part | Motorcraft AST-913 | Same label as the dealer parts counter |
| Mounts and springs are in good shape | Monroe 72889 or Motorcraft | A bare strut reuses them and costs less |
| You want written design and warranty details | Monroe 72889 | Listing prints both |
| No spring compressor, or mounts are tired | Monroe Quick-Strut 372889 | New spring and mount, bolts straight in |
| Only one corner is leaking | Any, but buy two | Mismatched sides dive and pull unevenly |
Owners on Ford forums tend to report that Motorcraft feels closest to the ride they remember, while Monroe gets credit for easy installs and broad availability. Those posts are not measured data, but they match what you would expect from a factory-tuned part on one side and a convenience-focused one on the other.
Grand Rapids Winters and Front Strut Hardware
Michigan road salt is hard on everything around a strut. The knuckle bolts, the sway bar link nut and the top mount nuts under the hood can all rust into place, and the link stud often spins when you try to loosen it. Soak the hardware with penetrating oil the night before and have new link nuts ready.

Spring potholes after a long freeze also put a lot of force through the front of a two-row crossover like the Edge. A rust-resistant finish helps here, and Monroe’s Quick-Strut listing calls out a protective coating with salt spray testing. Whichever brand you choose, look over the struts at each seasonal tire change for oil on the body, a split dust boot or a cracked mount.
If you are swapping bare struts at home, the spring is the part that can hurt you. Read our coil spring compressor buying guide before you start, use a clamp rated for strut springs, and never point a compressed spring at yourself.

The front strut also bolts to the steering knuckle on the Edge, so removing it can change camber and toe. Book a four-wheel alignment once both sides are done, even if the vehicle seems to track straight on the drive home.
When the Job Belongs in a Shop
Before buying anything, make sure the struts are the real problem. Our guide on how to tell if struts are bad walks through bounce, nose dive, leaks and cupped tires. A squeak over speed bumps often comes from dry bushings or links instead, and our article on why a car squeaks when going over bumps helps narrow it down.
Bolts that will not break loose, no safe way to compress a spring, or a pull that shows up after the swap are all good reasons to hand the Edge over. Our shop offers suspension repair in Grand Rapids for foreign and domestic vehicles. Hendrick Hoffman is ASE and State of Michigan certified in steering and suspension, so strut replacement is routine work here.
More Buying Guides
Frequently Asked Questions
Is Motorcraft or Monroe the better strut brand?
In the monroe vs motorcraft struts choice there is no measured winner, because neither brand publishes damping data for the Edge. Motorcraft is the Ford-branded part, while Monroe prints its design features and a lifetime defect warranty. Pick the one whose fit, documentation and support suit you.
Is a Motorcraft strut the same part that came on my Ford?
Motorcraft is Ford’s own parts brand, so it is the closest you can get through normal channels. Ford can supersede part numbers over time, so match the number with a dealer parts counter using your VIN rather than assuming it is identical to the original.
Will I need a spring compressor to fit these struts?
For the Motorcraft AST-913 and the Monroe 72889, yes, because both are bare struts and your old spring and mount move over. The Monroe Quick-Strut 372889 comes fully assembled, so it does not need one.
Do I need an alignment after replacing Edge front struts?
Yes. The strut bolts to the steering knuckle and helps set the wheel angles, so removing it can shift them. An alignment after the job protects your tires and keeps the steering centered.
Edge feeling loose or noisy on rough Grand Rapids streets? Call 456 AutoFix at 616-279-3832, Monday to Friday from 8am to 5pm, or request a front suspension check on our contact page.
If your workday lines up with our hours, drop the Edge at 456 Carrier St NE after we close, use the after-hours drop-off, and leave a note about which corner clunks.
