As an Amazon Associate, 456 AutoFix earns from qualifying purchases. Product links below go to Amazon, where you can confirm the right part for your vehicle.
Hook up a 25 foot camper and the inside mirror of your truck shows nothing but the front wall of the trailer. Finding the best backup camera for travel trailer towing starts with one quick look at the back of your camper: is there a small camera prep plate up top, or just bare siding?
That answer splits the choices into two groups: cameras that mount on a factory prep and take power from the trailer, and battery cameras that hold on with magnets and charge from the sun. Both send video wirelessly to a screen on your dash.
Quick answer
What camera should go on the back of a travel trailer?
If the trailer has a Furrion style prep plate, a prewire camera such as the Furrion Vision S+ bolts on and runs off trailer power. With no prep, a magnetic solar camera like the pemacom 1440P needs no wiring at all. Want tire pressure on the same screen? Look at the Haloview BT7 TPMS.
Our Quick Picks
Three routes: a prewire camera for a factory prep plate, a magnetic solar camera for bare walls, and a camera with tire pressure alerts.

Furrion Vision S+ 7 in
The maker's own system for trailers with a factory camera prep.

pemacom 1440P Magnetic
Magnetic solar camera with a steel plate for aluminum or fiberglass walls.

Haloview BT7 TPMS
One screen for the rear view and the trailer's tire pressures.
Look for a Prep Plate on the Rear Wall
Many travel trailers leave the factory “prewired” for a rear camera. In practice that means a small plate, usually high on the back wall near the center marker lights, with a 12V power lead behind it. The video does not run through the trailer at all, because the camera transmits it wirelessly to the monitor in the tow vehicle.
On many trailers that prep is fed from the running light circuit. The camera then works only when the trailer lights are on, which owners often discover the first time they back in at a campsite with the headlights off. Your owner’s manual or the trailer maker can confirm which circuit feeds it.
No plate? A battery camera that sticks on with magnets is the simple route. Most travel trailer walls are aluminum or fiberglass, though, and a magnet needs steel, so check that the camera ships with a steel mounting plate, or plan to add one.
Signal Range, Screen Size and Extra Cameras
Add the trailer length to the truck length and measure from the camera to the dash. A 30 foot trailer behind a crew cab pickup can put the camera close to 50 feet from the screen, with two metal bodies in between. Pick a system whose listed range on a vehicle, not in open air, covers that distance with room to spare.
Recording to an SD card turns the system into a rear dash cam, and a second camera on the hitch or a side wall helps with lane changes and hooking up. Our wireless backup camera guide covers smaller car kits, and the backup camera buying guide explains the wired and mirror options.
Best Backup Camera for Travel Trailer Picks, One at a Time
Three of the six below mount on a factory prep, two hold on with magnets, and one adds tire pressure readings to the camera view. Specs come from each Amazon listing.
1. Furrion Vision S+ FOS7HTASF: 7 in Touchscreen with 1080p Sharkfin Camera

- Sharkfin camera fits the prep many RVs ship with
- 1080p IP65 camera with infrared night vision
- 2.4 GHz link tested to 100 ft at speed
- Monitor shows up to four camera views
The Vision S+ is Furrion’s current wireless observation system, and the listing notes that most RVs are already prepped for its camera, so mounting it usually needs no extra drilling. It pairs one sharkfin camera with a 7 inch touchscreen. The camera records in 1080p, carries an IP65 waterproof rating and uses infrared night vision with an automatic IR cut filter across a 140 degree view.
Video travels over a proprietary 2.4 GHz digital link. Furrion lists it as tested to 100 feet at highway speeds, with up to 492 feet in open spaces. The anti-glare screen shows park assist lines, mounts on the windshield or a table, and can display up to four cameras if you add side or front views later.
Motion sensors in the camera can wake the display while you are parked, and a built-in microphone carries sound. The monitor records to an SD card, but the card is not included. Because the camera draws power from the trailer’s prep, it suits owners who want a fixed setup rather than one they remove, and it will not help a trailer that has no prep or power lead.
View Furrion Vision S+ 7 in on Amazon
2. AMTIFO 1080P RV Backup Camera: 7 in DVR Monitor for Furrion Pre-Wired RVs

- Adapter plate and pigtail for Furrion prewire
- All-metal camera housing with IP69 rating
- Dual antenna 2.4 GHz digital signal
- Loop recording and up to four cameras
AMTIFO builds this camera for trailers that came prewired for Furrion. The box includes a Furrion style mounting bracket adapter plate and a pigtail wire, so the camera bolts to the existing prep and takes power from it. The listing also mentions a test cord for checking the system on the ground before mounting.
The camera sits in an all-metal housing rated IP69 and uses a 1080P sensor with a 150 degree field of view. Infrared night vision reaches about 20 feet, according to the listing. The 2.4 GHz digital link uses dual antennas, with a stated range of 825 feet in open areas and under 320 feet on a vehicle.
The 7 inch monitor handles up to four cameras, so you could add one at the hitch or inside a horse or cargo trailer. It records to an SD card in a loop, overwriting old files when the card fills. Touch keys switch between front and rear views and turn the guide lines on or off, and the lines can be moved up or down. Owners without a Furrion prep would need to arrange their own 12V power feed.
View AMTIFO 1080P RV Camera on Amazon

3. pemacom 1440P Magnetic RV Backup Camera: 7.3 in DVR Monitor with Solar Battery

- Six N52 magnets with a soft rubber base
- Iron sheet bracket for non-metal trailer walls
- 7W solar panel and 16200 mAh battery
- 170 degree view, IP69, loop recording
This pemacom system skips trailer wiring altogether. The camera runs on a 16200 mAh lithium battery topped up by a built-in 7W solar panel, and the listing quotes up to 27 hours of continuous use on a full charge. On cloudy stretches, the included 5V 2A charger refills it in about six hours.
Six N52 magnets and a soft rubber base hold the camera in place without drilling. That matters on a travel trailer, because most walls are aluminum, wood or fiberglass rather than steel. pemacom includes an iron sheet bracket for those surfaces, so the magnets have something to grip, and the listing names THOR and Forest River towables among the trailers it fits.
Video comes through at 1440P with a 170 degree view, shown on a 7.3 inch IPS monitor. The listed working range is 65 feet on the vehicle, up to 1640 feet in open terrain, and the monitor loop records to an SD card of up to 128GB. The housing is rated IP69, accepts a second camera channel and is listed for use from -22°F to 176°F. You will need to remember to charge it after long cloudy spells or winter storage.
View pemacom 1440P Magnetic on Amazon
4. Yakry 1296P Magnetic Wireless RV Camera: 7 in Monitor with 26800 mAh Battery

- Six N52 magnets rated to 55 lb of hold
- 26800 mAh battery with 7W solar assist
- 2304 x 1296 resolution at 30fps
- 24dBm transmitter, dual antenna monitor
Yakry’s 1296P camera is built around a large 26800 mAh battery. The listing says it runs for up to 48 hours of continuous use on a full charge without help from the sun. A 7W solar panel tops the battery up while it works, and a USB-C port takes a 5V 2A charger when sunlight is short.
Mounting relies on six N52 rare earth magnets with a quoted 25 kg, or 55 lb, of holding force, and the listing rates it for speeds up to 75 MPH. A silicone layer protects the paint and helps grip. Yakry specifies a flat steel surface, so on an aluminum or fiberglass trailer you would need to fit a steel plate before relying on it at highway speed.
The camera uses a 3MP sensor to deliver 2304 by 1296 video at 30 frames per second, shown on a 7 inch monitor. A 24dBm transmitter and a dual antenna receiver give a tested range of about 65 feet, which suits most travel trailer and truck combinations. It suits owners who camp for several days and would rather not charge between stops.
View Yakry 1296P Magnetic on Amazon

5. AUTO-VOX Wireless RV Backup Camera: 7.2 in 1080P DVR Monitor for Pre-Wired RVs

- 20 to 30 minute install on pre-wired RVs
- Adapters for taillight power on other rigs
- Dual antennas for rigs up to 60 feet
- 32GB card included, up to three cameras
AUTO-VOX designed this kit to fit the camera housing on factory pre-wired RVs, and the listing puts installation at 20 to 30 minutes on those trailers with no extra drilling. For a trailer without a prep, adapters are included to take power from a taillight instead. That flexibility makes it a practical choice if you are not sure what is behind the back wall of an older camper.
The 7.2 inch widescreen monitor shows 1080P video, and the wide-angle lens helps with tight campground loops and storage lots. Dual antennas are designed to hold the connection on trailers and fifth wheels up to 60 feet. Infrared night vision switches on automatically when the light fades.
The system supports up to three cameras, with a three-way split screen for the rear and both sides. A 32GB card comes in the box, so the monitor can record the drive from day one. Taillight power means the camera only works when that light circuit is live, so check how your trailer’s lights behave before you depend on it for backing at night. Confirm the housing fits your prep before ordering.
View AUTO-VOX RV Camera on Amazon
6. Haloview Byte Tango BT7 TPMS: 1080P Wireless Camera with 4 Tire Pressure Sensors

- Camera view with live tire pressure overlay
- Four sensors with pressure and temperature
- Alerts for leaks, heat and lost signal
- 1080P recording, up to four cameras
Haloview’s BT7 TPMS puts a wireless backup camera and a tire pressure monitoring system on the same monitor. This version ships with four sensors, enough for a tandem axle trailer. Pressure and temperature readings appear over the camera view and cycle through each tire every five seconds, so you do not have to leave the camera picture to check them.
The alert list covers high and low pressure, high temperature, fast and slow leaks, a lost sensor signal and a low sensor battery, with both visual and audio warnings. You can turn the overlay off or change its transparency if it blocks part of the rear view. Pairing works through an AUTO Learn button or by entering sensor IDs by hand.
The camera side records in 1080P and works with Haloview’s Byte Tango cameras, supporting up to four views around the rig. A trailer tire that loses air is easy to miss from the driver’s seat, so a combined screen suits owners who tow long distances on highways. Check the camera mounting and power details on the listing, and confirm the sensor pressure range suits your trailer tires, before ordering.
View Haloview BT7 TPMS on Amazon
Which Camera Fits Your Camper?
| Your trailer | Camera style | Pick from this page | Watch for |
|---|---|---|---|
| Factory prep plate, want the maker’s system | Prewire sharkfin | Furrion Vision S+ | SD card sold separately |
| Factory prep, want recording and extra channels | Prewire kit with DVR | AMTIFO 1080P or AUTO-VOX RV | Running light power |
| No prep, steel surface available | Magnetic solar | Yakry 1296P | Flat steel needed |
| No prep, aluminum or fiberglass skin | Magnetic with steel plate | pemacom 1440P | Plate adhesion |
| Want tire alerts too | Camera plus TPMS | Haloview BT7 TPMS | Sensor setup |
A camera does not replace a spotter. THOR Industries’ tips for backing up a travel trailer still put slow speed, a spotter with agreed hand signals and tow mirrors first, plus keeping your hands at the bottom of the wheel to avoid oversteering.

Once the trailer is in place, chock the wheels before you unhitch; our wheel chocks for trailers page covers sizes. If your tow vehicle has no camera of its own for lining up the hitch, the backup camera for trucks guide covers tailgate mounts.
Camping Season and Winter Storage in West Michigan
Spring trips out of Grand Rapids often start on roads that still carry winter salt, and the back wall of a trailer catches spray from the truck’s tires. Wipe the lens at fuel stops, and look for an IP69 or IP69K rating on any camera mounted low.
Lithium battery cameras lose run time in the cold, and a camper parked under a cover all winter gives a solar panel nothing to work with. Taking a magnetic camera off for storage and charging it indoors keeps it ready for spring.

A prewire camera can stay on the trailer, but check the plate seal each season. For a trailer that sits outside from November to April, the best backup camera for travel trailer storage is often the one you can unclip and bring inside.
Wiring Faults That Point to the Tow Vehicle
When a prewire camera stays dark, check the trailer running lights first. If they are out too, the fault may sit in the truck’s 7-pin connector, a tow fuse or the trailer harness. A tow circuit that keeps popping fuses is a short that needs tracing, and our guide on why a car fuse keeps blowing explains how.

Most of these monitors plug into a 12V socket. In some trucks that socket stays live with the key off, so a screen left plugged in during a campground stay can be why the car battery dies overnight. Unplug it, or use a socket that switches off with the ignition.
If the truck’s lighting circuits or sockets keep acting up, our car electrical repair in Grand Rapids team can test the wiring and find the fault before your next trip.
More Buying Guides
Frequently Asked Questions
What is the best backup camera for a travel trailer?
It depends on the trailer. With a factory prep plate, a prewire camera such as the Furrion Vision S+ is the simplest fit. Without one, a magnetic solar camera with a steel mounting plate avoids drilling and wiring.
Does my trailer have to be prewired for a wireless camera?
No. The prep only supplies power to the camera, since the video travels wirelessly. Battery cameras need no prep at all, and some kits include adapters to take power from a taillight.
Why does my trailer camera only work with the lights on?
On many trailers the camera prep is wired to the running light circuit. Switch the truck’s headlights or parking lights on before backing, and the camera should power up.
Will a magnetic camera stay on at highway speed?
Listings for strong magnetic models rate them for highway use on a flat steel surface. On aluminum or fiberglass, the magnet only holds as well as the steel plate and its adhesive.
Trailer lights dead, a tow fuse that won’t stay in or a truck battery flat after a weekend at the campground? Give 456 AutoFix a call at 616-279-3832 on any weekday between 8am and 5pm, or set up a visit on our contact page.
Busy until after closing? Our after-hours drop-off at 456 Carrier St NE in Grand Rapids means the truck can be waiting for us when we open.
