As an Amazon Associate, 456 AutoFix earns from qualifying purchases. Product links below go to Amazon, where you can confirm the right part for your vehicle.
Trailer tires sit out of sight behind you, so a slow leak can run for miles before you notice the sway or smell the rubber. The best tire pressure monitoring system for trailers puts every trailer tire on a screen in the cab and sounds an alarm the moment pressure or heat drifts out of range.
Below we cover what a trailer kit has to cope with and how to size one, then review six systems built for campers, fifth wheels and utility trailers. If your tow vehicle’s own sensors need attention, our guide to replacement TPMS sensors covers that side.
Quick answer
Which TPMS works well on a trailer?
Pick a kit with one sensor per trailer tire, a pressure range above your tires’ maximum, temperature alarms and a repeater or booster for long rigs. The TST 507 with cap sensors suits most travel trailers, the GUTA GT30 covers multi-axle setups and the Tymate TM2 is a simple starter kit.
Our Quick Picks
Three quick picks for the most common towing setups: a travel trailer kit with a repeater in the box, a ten-sensor kit for multi-axle rigs and a simple four-sensor starter. All six are reviewed below.

TST 507 Series
A complete trailer kit with a color monitor and a repeater in the box.

GUTA GT30
Enough sensors for a truck and a tandem or triple axle trailer.

Tymate TM2
A simple solar-charged kit for smaller trailers.
Why Trailer Tires Need Their Own Monitor
Most trailers have no factory TPMS, and the truck’s own system only reads the truck. On a tandem axle, a trailer tire can lose half its air before you feel anything through the hitch.
Heat is the other risk. An underinflated tire flexes more, runs hotter and can fail at highway speed. An aftermarket kit reads pressure and temperature at each valve stem and warns you on the dash before a soft tire becomes a blowout.
A monitor does not replace a gauge, though. The U.S. Tire Manufacturers Association’s tire care guidance says to check pressure with a gauge when tires are cold and before you tow. Keep a reliable tire pressure gauge in the truck and use the TPMS as your warning system between checks.
Sizing a Kit: Sensors, Range and Signal
- Sensor count: count every trailer tire, then add the truck’s tires if you want one screen for the whole rig. Extra sensors can usually be added later.
- Pressure range: many trailer tires run well above passenger car pressures. Check the maximum on your sidewall and choose a kit whose listed range sits comfortably above it.
- Signal: the trailer body and its metal frame block radio signals. Long travel trailers and fifth wheels usually need a repeater or booster, and several kits include one in the box.
- Sensor style: cap sensors screw on in seconds. Flow-through sensors let you add air without removing them, which helps if you top up often.
Valve stems matter too. Most makers recommend metal valve stems for cap sensors, because the extra weight can flex a rubber snap-in stem at speed until it cracks or leaks. If your trailer still has rubber stems, have a tire shop fit metal ones before you install sensors.
Best Tire Pressure Monitoring System for Trailers: Six Kits Reviewed
Every kit below reads pressure and temperature and alarms on fast leaks, according to its maker or listing. Specs are as listed, so confirm the sensor count and pressure range against your own trailer before you order.
1. TST 507 Series TPMS: 4 Cap Sensors with Color Monitor and Repeater

- 4 cap sensors with user-replaceable CR2032 batteries
- 3.5-inch color display with rechargeable battery
- Repeater, magnetic mount and dash mounts included
- Expands to the tow vehicle plus up to four towables
The TST 507 Series from Truck System Technologies is a tire pressure monitoring kit sold for RVs, travel trailers and campers. This version comes with four cap sensors that screw onto the valve stems, a 3.5-inch color monitor, a repeater, a magnetic mount and a charging cable. Having the repeater in the box matters on a trailer, because the body and frame can weaken the signal before it reaches the cab.
The monitor alerts you to low pressure, high pressure, fast leaks and high temperature with both a sound and a visual warning. When an alarm goes off, the screen locks onto the problem tire so you can see which one needs attention. The display has a rechargeable battery with a Micro-USB charger and comes with suction cup and rubber dash mounts.
TST lists the system as expandable to your tow truck plus up to four towed vehicles, and tire positions can be swapped after a rotation. The sensors warn you when their batteries run low, and the batteries are user-replaceable. TST backs the complete kit with a three-year warranty and US-based customer service. Four sensors suit a tandem axle trailer, so a larger rig needs extra sensors.
2. TireMinder i10 RV TPMS: 4 Transmitters with Signal Booster, 0-199 PSI

- Monitors up to 40 tires
- 0 to 199 psi range, listed accuracy of +/- 1 psi
- 3.15-inch color LCD shows pressure or temperature
- Rhino signal booster included
The TireMinder i10 is an RV tire pressure monitoring system that pairs a 3.15-inch color LCD monitor with wireless transmitters on each valve stem. This kit includes four transmitters and the Rhino signal booster, which helps the signal reach the cab on longer trailers and motorhomes. The screen can show pressure or temperature readings for the tires at the same time.
TireMinder lists a pressure range of 0 to 199 psi with an accuracy of plus or minus 1 psi. That wide range leaves headroom for higher-pressure trailer and motorhome tires, which some cheaper kits cannot read. The system checks the tires every 6 seconds and warns of slow leaks, rapid leaks, blowouts, low pressure, high pressure and high temperature.
The monitor can track up to 40 tires, so you can add transmitters for the tow vehicle, a second trailer or a towed car later on. Four transmitters cover a tandem axle trailer, and larger bundles are sold for bigger setups. Like most cap-style transmitters, these are best fitted to metal valve stems. Check your tire count before ordering, since every extra tire needs its own transmitter.

3. EEZTire TPMS Pro 518C: 4 Sensors with 3.5-Inch Color Display, Up to 210 PSI

- Reads up to 26 tires and up to 210 psi
- Separate controls for RV and trailer sensors
- Configurable high temperature alarm
- Built-in battery listed at up to 60 hours
The EEZTire TPMS Pro 518C from EEZ RV Products monitors tire pressure and temperature on a 3.5-inch color display. The base kit comes with four sensors, and the system can grow to 26 sensors with pressures up to 210 psi. EEZ notes that this model does not work with its earlier T515, E518 or E618 systems, so do not mix parts from an older kit. It suits motorhome owners who tow a trailer or a car behind them.
The monitor has separate controls for the RV and trailer sensors. That lets you switch off the trailer group when you drive without it, so you do not get missing-sensor warnings. Readings update at 6-second intervals, the high temperature alarm can be adjusted, and alerts are both audible and visual.
The monitor is motion-sensitive and goes into power saving mode after 15 minutes without movement. Its built-in lithium battery is listed at up to 60 hours per charge, and it comes with a USB cable for the 12V socket or a USB port. The sensors use replaceable batteries. A signal booster is not listed in this four-sensor box, so long trailers may need one added.
View EEZTire TPMS Pro 518C on Amazon
4. GUTA GT30 Trailer TPMS: 10 Sensors with Signal Booster, 0-188 PSI

- 10 anti-theft cap sensors in the box
- Monitors up to 46 tires across 3 trailers
- 0 to 188 psi and up to 185 degrees F
- Signal booster and rechargeable monitor
The GUTA GT30 is a trailer tire pressure monitoring kit sold with ten sensors and a signal booster. Ten sensors cover a pickup and a tandem axle trailer, or a triple axle trailer with room to spare. The monitor shows up to 10 tires on one page and switches between the tow vehicle and trailer sections on its own, and the system can track up to 46 tires across three trailers.
GUTA lists a pressure range up to 188 psi and a temperature range up to 185 degrees F. Alarms cover high and low pressure, high temperature, fast leaks, a missing sensor signal and low sensor battery. After pairing, the system takes the current pressure as its reference and sets alarms at 25 percent above or 15 percent below it.
The anti-theft sensors are programmed wirelessly before you fit them, which makes setup simpler on a large rig. GUTA lists sensor battery life at up to four years on a replaceable CR2032 cell, and the monitor runs about 12 to 14 days on a full charge. The maker recommends metal valve stems for these cap sensors and does not recommend rubber stems.

5. Masoll RV TPMS: 4 Sensors with Booster, 0-145 PSI and 120 ft Range

- 4 factory-paired sensors with position labels
- Pressure range up to 145 psi
- Sealed booster for up to 120 ft transmission
- Color LCD with 4 brightness levels
The Masoll RV tire pressure monitoring system is built for travel trailers, fifth wheels and campers. This set comes with four sensors and a signal booster, and Masoll also sells kits with two, six or eight sensors. The listing says it works on rigs with tire pressures under 145 psi and a total length under 120 feet.
The sensors are paired to the monitor at the factory and labeled by wheel position, so installation means powering the monitor and screwing each sensor onto its matching valve. When you fit them, the system records the current pressure as its reference. It then alarms if pressure rises 25 percent above or drops 15 percent below that figure.
The booster is fully sealed with an IP69 rating and has built-in high voltage protection, and a booster symbol stays on the screen while it is working. Alarms cover high and low pressure, high temperature, fast leaks, a lost sensor and low sensor voltage. The color display has four brightness levels for day and night driving. Set your tires to the correct cold pressure before you install the sensors, since that sets the baseline.
6. Tymate TM2 RV TPMS: 4 Sensors with Solar and USB Charging

- 4 pre-labeled, factory-paired sensors
- Monitor shows up to 10 tires
- Solar charging plus USB charging
- Six alarm modes including fast leak
The Tymate TM2 is a compact tire pressure monitoring system with four sensors and a solar-charged monitor. It can display up to 10 tires and swaps between the front vehicle and the trailer, so four sensors cover a tandem axle trailer with room to add the truck later. The sensors arrive pre-labeled and paired at the factory, so there is no pairing step before you install them.
The monitor charges from its solar panel and can also charge by USB or from the 12V socket, though the socket adapter is not included. It adjusts its backlight automatically for night driving. There are six alarm modes: fast leak, high and low pressure, high temperature, sensor low voltage and lost signal, with thresholds set from the reference pressure at pairing.
Tymate lists the IP67 sensors at up to six months per CR1632 battery and recommends its separate repeater for rigs 36 feet or longer. The listing gives two different pressure ranges, 0 to 144 psi in the title and 0 to 87 psi in the details. If your trailer tires run above 80 psi, confirm the range with Tymate before you buy. The maker also recommends metal valve stems.
The Six Trailer Kits at a Glance
| Kit | Sensors in box | Signal help | Good fit |
|---|---|---|---|
| TST 507 Series | 4 cap sensors | Repeater included | Travel trailers and campers |
| TireMinder i10 | 4 transmitters | Signal booster included | Long rigs and motorhomes towing |
| EEZTire TPMS Pro 518C | 4 sensors | No booster listed in the box | Motorhomes with a towed trailer or car |
| GUTA GT30 | 10 sensors | Signal booster included | Tandem and triple axle setups |
| Masoll RV TPMS | 4 sensors | Booster included | Fifth wheels and longer campers |
| Tymate TM2 | 4 sensors | Repeater sold separately | Short trailers and first-time buyers |
If you tow a short single-axle utility trailer, a four-sensor kit without a booster usually covers it. Longer or multi-axle rigs need a repeater and more sensors.

Towing Season in West Michigan: Cold Mornings and Salt
Spring and fall trips bring cold starts, and USTMA notes that pressure drops one to two psi for every 10 degrees the air cools. A trailer set on a warm afternoon can trip a low-pressure alarm on a frosty morning, so recheck with a gauge and top up before you assume a leak. Our truck tire inflator guide covers compressors that can reach trailer pressures.
Road salt is hard on sensors and stems. Before the trailer goes into storage, take the cap sensors off, rinse the threads and store the sensors and monitor indoors. Chock the wheels with a set from our trailer wheel chock roundup and check that the sensor batteries still report before the first trip of spring.

Hot Wheels, Dead Monitors and When to Call Us
A temperature alarm on one wheel with normal pressure is not always a tire problem. A dragging brake or a dry, failing wheel bearing can heat the hub and the tire with it. If one corner keeps running hot, have the bearings checked through our wheel bearing replacement service before the next long tow.
Most monitors charge from the 12V socket, so a dead screen can point back to the truck. A socket that keeps going dead may be a blown fuse, and our article on why a car fuse keeps blowing explains the usual causes. Leaving the monitor, a charger or an inverter plugged in while parked can also drain the battery, which our car battery dies overnight guide walks through.

If you run campsite gear from the truck, size the wiring properly and read our best power inverter for car guide first. When a socket stops working, fuses keep failing or the battery goes flat between trips, book car electrical repair in Grand Rapids and we will trace the circuit.
More Buying Guides
Frequently Asked Questions
What is the best tire pressure monitoring system for travel trailers?
For most travel trailers, a four or six sensor kit with temperature alarms and a repeater fits well. The TST 507 Series is a common choice, while the GUTA GT30 suits larger multi-axle trailers. Match the kit’s listed pressure range and signal reach to your trailer.
Do I need a signal booster for my trailer TPMS?
On short trailers, often not. Longer travel trailers and fifth wheels can block the signal, and several makers recommend a booster once the rig passes about 36 to 38 feet. Mount it near the middle of the trailer, away from large metal panels.
Can I use cap sensors on rubber valve stems?
Makers such as GUTA and Tymate recommend metal valve stems. A cap sensor adds weight that can flex a rubber stem at highway speed, which can cause leaks. Ask a tire shop to swap in metal stems before you fit sensors.
Can one monitor read both my truck and trailer tires?
Many can. The TST 507, EEZTire and GUTA kits all list support for the tow vehicle plus trailer tires. You buy extra sensors for the truck and pair them to the same monitor.
Got a trailer wheel that runs hot or a truck socket that won’t power your monitor? Ring 456 AutoFix at 616-279-3832 between 8am and 5pm, Monday through Friday, or set up a visit through our contact page.
Working when we’re open? Drop the keys after hours at our shop, 456 Carrier St NE, Grand Rapids.
