456 Carrier St NE, Grand Rapids, MI 49505 Mon to Fri, 8:00am to 5:00pm. After-hours drop-off available 456autofix@gmail.com

Same CR-V, Two Lower Arms: Moog vs Detroit Axle Control Arms

moog vs detroit axle control arms: desert road stretching into the horizon with dramatic sky and distant mountains

As an Amazon Associate, 456 AutoFix earns from qualifying purchases. Product links below go to Amazon, where you can confirm the right part for your vehicle.

A worn front lower arm on a 2007-2011 Honda CR-V usually announces itself with a knock over broken pavement and a front tire that wears on one edge. When you start shopping, the moog vs detroit axle control arms question comes up fast, because both brands list this exact part on Amazon and they sell it in very different ways.

To keep the comparison honest, we held the vehicle and position steady: front lower arm with ball joint, third-generation CR-V. Every product fact below comes from the Amazon US listings or MOOG’s own pages, and we flag anything a listing leaves out. Always enter your year, trim and VIN details on Amazon before you order, since a listing that looks right can still miss a build variation.

Quick answer

On a 2007-2011 CR-V front lower arm, should you pick MOOG or Detroit Axle?

Pick the MOOG RK620500 if you want a name-brand arm, one side at a time, and plan a professional install through an authorized seller. Pick the Detroit Axle pair if you want both sides in one box with a 10-year warranty stated on the listing. Both carry the ball joint already fitted.

Our Quick Picks

MOOG's driver-side arm, Detroit Axle's matching pair and its larger front end kit, all for the 2007-2011 Honda CR-V and covered in full below.

MOOG RK620500 product photo
Single-side pick

MOOG RK620500

Front left lower, ball joint fitted

Name-brand driver-side arm for owners replacing one corner at a time.

SuitsOne worn side, shop installs through an authorized seller
View on Amazon →
Detroit Axle Pair product photo
Both-sides pick

Detroit Axle Pair

Front left and right lower, ball joints fitted

Two complete arms in one order, with a 10-year warranty in the bullets.

SuitsHigh-mileage CR-Vs with wear on both corners, DIY installs
View on Amazon →
Detroit Axle 8pc Kit product photo
Full front end pick

Detroit Axle 8pc Kit

8 pieces, Japan-built 2007-2011 CR-V

Lower arms plus tie rods and end links when the whole front end is tired.

SuitsFront ends with several worn joints, owners chasing more than one noise
View on Amazon →

Two Ways to Sell the Same CR-V Arm

MOOG is a steering and suspension brand owned by DRiV, which describes it as a premium replacement line for cars, light trucks and SUVs. Its CR-V lower arms are sold per side: RK620500 for the driver side and RK620501 for the passenger side. Detroit Axle is a Michigan parts company that leans toward pairs and complete front end kits, so one order can cover both corners plus the steering links around them.

That packaging difference shapes the whole decision. If only one arm is worn, a single MOOG arm is the smaller job. If both bushings are cracked after a dozen Michigan winters, a pair saves a second order and keeps both sides at the same age.

On this CR-V the lower ball joint comes as part of the arm assembly on both brands’ listings, so you are not pressing a separate joint. MOOG’s guide to signs of a failing control arm describes the arm as a body, a ball joint and bushings, and names potholes, curbs and road salt corrosion as common causes of damage. All three are part of everyday driving in West Michigan, where freeze-thaw potholes and brine-soaked roads arrive every winter.

What Each Listing Puts on Paper

Neither brand publishes much detail on Amazon for this part, so the table keeps to what is stated and marks the blanks.

PointMOOG RK620500Detroit Axle pair
Fitment on the listing2007-2011 Honda CR-V2007-2011 Honda CR-V
PositionFront left (driver side) lowerFront left and right lower
Ball jointIncluded in the assemblyIncluded on both arms
BushingsNot described in the bulletsNot described in the bullets
Testing claimNot statedImpact, wear and fatigue testing
WarrantyNot in the bullets; see MOOG’s warranty page10 years on the listing
Moog vs Detroit Axle control arms for the 2007-2011 CR-V, as listed on Amazon US

The gaps matter as much as the filled cells. Neither listing gives a bushing material or a coating, so any claim that one arm resists rust better would be a guess. What you can compare with confidence is the box contents, the stated warranty and how each brand expects you to buy.

Moog vs Detroit Axle Control Arms for the CR-V, Reviewed

Two arms cover the head-to-head, and the third pick is Detroit Axle’s larger kit for owners whose tie rods are tired too. Check the first digit of your VIN before you consider that kit.

MOOG RK620500: Front Left Lower Control Arm and Ball Joint for 2007-2011 Honda CR-V

MOOG RK620500 product photo
Key features
  • Front left (driver side) lower arm
  • Ball joint comes fitted in the assembly
  • Listed for 2007-2011 Honda CR-V
  • MOOG chassis line from DRiV

The MOOG RK620500 is a complete front lower control arm for the driver side of the 2007-2011 Honda CR-V. The ball joint arrives already installed in the arm, so the job is a bolt-out, bolt-in swap of the assembly rather than pressing a joint into an old arm. MOOG is a DRiV brand, and its listing describes the part as built to hold suspension geometry and steady handling under everyday road stress.

Because it covers one side only, this arm suits a CR-V where a single bushing has torn or one ball joint has developed play while the other side still checks out. The passenger-side partner is RK620501, sold as its own listing, so you can buy the second arm later or order both at once if they are equally worn. Fitting matching arms on both sides keeps the front end aging evenly.

The Amazon bullets are brief and do not list bushing material, coating or a warranty term. MOOG’s own warranty page sets the rules: lifetime coverage applies to parts bought and professionally installed through authorized dealers. If you plan to fit the arm yourself in the driveway, or buy from a marketplace seller, treat the return policy as your real protection and plan on an alignment afterward.

View MOOG RK620500 on Amazon

empty road running through grassy terrain with green plants under blue cloudy sky

Detroit Axle Front Lower Control Arms: Pair with Ball Joints for 2007-2011 Honda CR-V

Detroit Axle Pair product photo
Key features
  • Two front lower arms, left and right
  • Ball joints already installed on both
  • Listed for 2007-2011 Honda CR-V
  • 10-year warranty stated on the listing

Detroit Axle’s pair covers both front lower control arms on the 2007-2011 Honda CR-V in a single box. Each arm comes with its ball joint already fitted, so you replace the whole assembly on each side and skip the press work. This is the direct counterpart to buying MOOG’s RK620500 and RK620501 separately, and it gives you two arms of identical age and design.

The listing states that Detroit Axle suspension parts go through impact, wear and fatigue testing, though it does not publish the method or the results. It also states a 10-year warranty, and the bullets mention no installer requirement. For a home mechanic with a floor jack, stands and a good breaker bar, that combination is the main appeal over a name brand that ties its longest coverage to a shop install.

As with MOOG, the bullets do not describe the bushing material or any corrosion coating, so there is no listed basis for claims about rust resistance. Expect to fight seized hardware on a CR-V that has seen years of salt, and order fresh bolts if yours look rough. Plan an alignment once both arms are torqued at ride height.

View Detroit Axle Pair on Amazon

Detroit Axle 8pc Front End Kit: Lower Control Arms, Tie Rod Ends and Sway Bar Links for Japan-Built 2007-2011 CR-V

Detroit Axle 8pc Kit product photo
Key features
  • 2 lower arms with ball joints fitted
  • 4 inner and outer tie rod ends
  • 2 front sway bar end links
  • Japan-built CR-Vs only (VIN starts with J)

This Detroit Axle kit builds on the two-arm pair by adding the parts that sit next to the lower arms. Inside are both front lower control arms with ball joints, four inner and outer tie rod ends and two front sway bar end links. It is listed for the 2007-2011 Honda CR-V, but only for Japan-built models, which you can identify by a VIN that starts with the letter J.

That fitment note matters. CR-Vs of this generation were also built outside Japan, and the listing limits the kit to the J models, so check the VIN on your door jamb or registration before ordering. If yours starts with a different letter, the plain pair above is the safer route for the arms, and the tie rods can be sourced separately.

The kit makes sense when a front end inspection turns up loose tie rods or knocking end links alongside worn arms, since one alignment then covers everything. The listing states the same testing claim and 10-year warranty as the pair. Replacing tie rod ends always changes toe, so a professional alignment after installation is part of the job, not an optional extra.

View Detroit Axle 8pc Kit on Amazon

straight empty road leading through vibrant canola fields under blue skies

Warranty Terms and Where You Buy

How MOOG words its coverage

The MOOG warranty page offers a limited lifetime warranty on qualifying chassis parts for the first retail buyer, for as long as that person owns the vehicle. The conditions are specific: the part must be bought and professionally installed at an authorized dealer. The page also says purchases through unauthorized online sellers, marketplaces and third-party sales are not eligible, and that removal and installation costs are never covered.

In practice, look at who is selling the MOOG listing before you add it to your cart, and keep the dated receipt. If the seller is not on MOOG’s authorized list, plan on the part being covered only by the seller’s return policy.

scenic highway in Montana with dramatic clouds and vast landscapes

How Detroit Axle states it

Detroit Axle’s listings put a 10-year warranty right in the feature bullets, with no installer requirement mentioned there. The listings also claim impact, wear and fatigue testing, though they do not publish the test method. Read the warranty terms on the order page before you install, and save the invoice, since most parts warranties replace the part only and leave labor to you.

Neither warranty pays for the alignment that follows a lower arm swap. Budget for one either way, because a new arm with fresh bushings sits the wheel slightly differently from the sagging part it replaces.

Matching the Arm to Your CR-V

Most of the moog vs detroit axle control arms decision comes down to how many corners are worn and how you plan to get the work done.

Your situationBetter fitWhy
Only the driver-side bushing is tornMOOG RK620500Sold as a single side
Both front lower arms clunk or the ball joints are looseDetroit Axle pairTwo arms in one box
Arms, tie rods and end links all worn on a Japan-built CR-VDetroit Axle 8pc kitLower arms plus steering and sway bar links
Shop install with a name-brand warrantyMOOG from an authorized sellerLifetime terms need an authorized dealer and pro install
Choosing between the CR-V lower arm options by job size

If you only need the passenger side, MOOG’s RK620501 is the matching part number, so you are not forced into the pair. When one side has failed on a high-mileage CR-V, though, the other is rarely far behind. Replacing both together also means one alignment instead of two.

Salt-belt cars add another wrinkle. The bolts that hold the rear bushing and the ball joint pinch bolt can seize after years of brine, and a stuck bolt can turn an afternoon job into a weekend. Soak them with penetrating oil the night before, and have a replacement bolt on hand in case one snaps.

off-road vehicle navigating muddy tracks in a forest setting during daytime adventure

A lower arm is only one part of how the front end feels. If the CR-V still bounces or floats after the arms are done, the struts may be the remaining weak link, and our guide to shocks and struts for daily drivers explains what to look for. For a wider look at the brands in this category, see our control arm brands roundup.

When a Mechanic Should Take Over

A clunk over bumps does not always mean a lower arm. Sway bar links, strut mounts and tie rod ends can all make similar noises, so it pays to confirm the source before you spend money on an arm you may not need. Our article on control arm failure symptoms is written around Audis, but the signs it walks through apply to most front ends.

4x4 vehicle splashes through muddy forest path during off-road adventure

The lower arm holds the wheel in place, so a loose ball joint or a cracked mount is a safety issue rather than a comfort one. If you would rather have the diagnosis and install handled for you, our team does suspension repair in Grand Rapids, checks the parts around the arm while the car is on the lift, and sets the alignment once the new parts are torqued.

Frequently Asked Questions

Is Detroit Axle as good as MOOG for control arms?

Neither brand publishes comparable test data on Amazon, so there is no fair way to rank build quality from the listings. Detroit Axle states impact, wear and fatigue testing and a 10-year warranty. MOOG offers a lifetime warranty, but only for parts bought and professionally installed through authorized dealers.

Does the MOOG RK620500 fit both sides of a CR-V?

No. RK620500 is the front left, or driver side, lower arm for the 2007-2011 CR-V. The passenger side uses RK620501, which is sold separately.

Will my truck need an alignment after a new lower control arm goes in?

Yes. A new arm with fresh bushings changes where the wheel sits compared with the worn part, which affects toe and camber. Skipping the alignment can wear a new set of tires on the edges within a season.

Which Detroit Axle kit fits my CR-V?

The two-arm pair lists all 2007-2011 CR-V models. The 8-piece kit lists only Japan-built models, meaning the VIN starts with the letter J, so check your VIN on the driver door jamb or registration first.

Hearing a knock from the front of your CR-V and not sure which part is behind it? Call 456 AutoFix at 616-279-3832, Monday to Friday 8am to 5pm, or request a front end inspection on our contact page.

When your shift ends after we lock up, drive the Honda over to 456 Carrier St NE, Grand Rapids, leave the keys in our after-hours drop-off with a quick note on which side knocks, and we will take it from there in the morning.