As an Amazon Associate, 456 AutoFix earns from qualifying purchases. Product links below go to Amazon, where you can confirm the right part for your vehicle.
An SUV sits in an awkward middle ground for jacks. It rides higher than a sedan, often weighs as much as a half-ton pickup, and many crossovers still hide their lift points behind plastic trim close to the ground. The best floor jack for SUVs reaches those points without scraping, climbs far enough to get a stand underneath, and carries the weight with margin left over.
This guide covers how to size a jack for your SUV, five jacks with listed specs that suit everything from a compact crossover to a three-row family hauler, and how to lift safely in a cold garage. If a lowered car shares your driveway, our roundup of low profile floor jacks for cars tackles the opposite clearance problem.
Quick answer
What size floor jack does an SUV need?
Most SUVs do well with a 3 to 4 ton jack that tops out near 20 inches or more. The Torin 3 Ton lifts 5.8 to 20.8 inches for mid-size models, the American Lifting AL2301 reaches nearly 23 inches for taller ones, and the Hein-Werner 4 Ton long chassis suits heavy three-row SUVs.
Our Quick Picks
Three jacks for the common SUV situations: a mid-size family SUV, a tall body-on-frame model and a heavy full-size three-row.

Torin 3 Ton SUV Jack
A tall-reaching steel jack sized for the typical family SUV.

American Lifting AL2301
Nearly 23 inches of travel for tall SUVs and frame lift points.

Hein-Werner HW93667
Professional-grade capacity and reach for the biggest SUVs.
Ride Height, Weight and the Numbers That Matter
Two figures on a jack listing do most of the work for an SUV owner: rated capacity and maximum height. Capacity is easier to get right than people think, because a floor jack raises one corner or one end, never the whole vehicle. Height is where most mistakes happen, since a jack that stops at 18 inches can leave a mid-size SUV tire still touching the floor.
For a rough weight class, the government size chart on FuelEconomy.gov splits SUVs by gross vehicle weight rating: small SUVs fall under 6,000 lbs and standard SUVs run from 6,000 to 9,999 lbs. A small SUV is comfortable territory for a 3 ton jack. Toward the top of the standard class, a 3.5 or 4 ton unit works further from its limit and tends to feel steadier.
Before you shop for the best floor jack for SUVs, take a tape measure to the vehicle itself, parked on level concrete:
- Clearance under the trim: the gap between the floor and the lowest part in the jack’s path, such as a skid plate or rocker cover.
- Lift point height: floor to the pinch weld, frame rail or axle point shown in your owner’s manual.
- Tire travel: the extra rise needed for the tire to leave the ground, plus room to place a stand.
The jack’s minimum height must fit under the first number, and its maximum height should beat the second and third added together. If the margin is an inch or less, step up to a taller jack.
Unibody Crossover or Body-on-Frame SUV?
Most crossovers are unibody designs that lift at reinforced pinch welds or marked pads along the rocker. Those points are lower than you might expect, so a jack that starts around 4 to 6 inches usually slides in without trouble. A rubber pad or slotted pinch weld adapter on the saddle keeps the seam from folding.
Body-on-frame SUVs behave more like pickups. You lift at the frame rails or, at the rear, often under the axle, and those points sit higher and carry more weight. A longer chassis helps here because it lets the saddle reach a center point from the side or the end without crawling under the bumper.
Not sure which one you have? The owner’s manual jacking diagram answers that question in a minute. If you are still building out your garage, our car maintenance tools for beginners list shows where a floor jack and stands sit among the first purchases.
Best Floor Jack for SUVs: Five Jacks Reviewed
Capacity and lift range below come from each Amazon listing. Hold them up against the measurements from your own SUV before you choose.
1. Torin 3 Ton Trolley Jack: 5.8 to 20.8 in. Lift for SUVs and Extended Height Trucks

- 3 ton (6,000 lb) rated capacity
- Lift range of 5.8 to 20.8 in.
- 360-degree swivel handle
- Extra saddle, safety bypass system
Torin sells this black steel trolley jack specifically for SUVs and extended height trucks, and the listing backs that up with a lift range of 5.8 to 20.8 inches. That top figure matters on a mid-size SUV, where an 18 inch jack can run out of travel before the tire clears the ground. The 5.8 inch starting height still fits under most crossover rockers and frame rails.
Capacity is listed at 3 tons, or 6,000 lbs, which covers one end of a typical two-row or three-row SUV with room to spare. A single piston quick lift pump raises the saddle toward the load, and a safety bypass system stops the jack from being pumped past its rating. The jack rolls on two large steel casters at the front and two 360-degree swivel casters at the back.
The handle also swivels a full 360 degrees, which helps when a wheel well or bumper forces you to pump from an angle. An extra saddle comes in the box. It is a heavy steel jack meant for the garage floor rather than the cargo area, so plan storage space for it, and confirm your lift point height against the 20.8 inch maximum before ordering.
View Torin 3 Ton SUV Jack on Amazon
2. American Lifting AL2301: 3 Ton Rapid Lift Floor Jack, 5 to 22-7/8 in.

- 3 ton rated capacity
- Lift range of 5 to 22-7/8 in.
- 6-3/4 in. swivel saddle, cast iron lift arm
- Metered release with U-joint control
The American Lifting AL2301 has the tallest maximum height in this group, with the listing giving a range of 5 to 22-7/8 inches. That extra reach is useful on body-on-frame SUVs and on crossovers with larger tires, where the frame rail or rear axle sits well off the floor. A 5 inch minimum keeps it usable under lower models as well.
Construction is heavy gauge, with a cast iron lift arm and flanged side plates intended to stiffen the chassis. The swivel saddle measures 6-3/4 inches across, which spreads the load on a frame rail and gives you a wider target when positioning. Rapid Lift lets the saddle rise quickly to the jacking point with no load on it, moving in steps of roughly 1/4 to 3/4 inch per stroke.
The pump is mounted in line to avoid off-center forces, and the sealed hydraulic unit includes a built-in bypass to guard against over pumping. A metered release and U-joint release mechanism let you lower the SUV slowly and with control. The wide saddle may need a pinch weld adapter on unibody crossovers, so check the jacking points in your owner’s manual first.
View American Lifting AL2301 on Amazon

3. Omega 29038: 3.5 Ton Low Profile Service Jack with Magic Lift, 4 to 21 in.

- 3.5 ton rated capacity
- Lift range of 4 to 21 in.
- Magic Lift fast rise to the load
- 4-3/4 in. swivel saddle, cast iron arm
The Omega 29038 is a 3.5 ton service jack that pairs a low 4 inch starting height with a 21 inch maximum, according to its listing. That spread suits crossovers that sit high overall but still have plastic cladding or air dams low in front of the lift points. It also gives a household with a sedan and an SUV one jack that can handle both.
Omega’s Magic Lift feature raises the saddle quickly to the jacking point when there is no weight on it, in roughly 1/4 to 3/4 inch increments. The frame uses heavy gauge construction with a cast iron lift arm and flanged side plates for rigidity. A swivel saddle 4-3/4 inches across makes it easier to line up on a pinch weld pad or a marked lift point.
The pump assembly is in line and sealed, which reduces wear and keeps contaminants out of the hydraulics. A built-in bypass protects against over pumping, and the metered release with a U-joint handle lets you lower in controlled steps from any handle angle. The extra half ton of rating over a 3 ton jack adds a welcome margin for heavier three-row crossovers.
4. Hein-Werner HW93667: 4 Ton Long Chassis Service Jack, Air or Manual

- 4 ton rated capacity
- Long chassis for hard-to-reach points
- Operates manually or with shop air
- Cast iron lift arm, made in USA
The Hein-Werner HW93667 is a 4 ton long chassis service jack, the heaviest-duty option on this list. Its rating leaves plenty of margin for the front or rear of a full-size three-row SUV, and the long chassis lets the saddle reach a central crossmember or axle point without you crawling under the bumper. Hein-Werner lists it as made in the USA.
This jack can be pumped by hand or run from shop air, so a garage with a compressor can raise a heavy SUV with less effort. A cast iron lift arm handles the loads, and the hydraulic unit is sealed to keep dirt and moisture out. The design is aimed at professional shops and serious home garages that work on big vehicles regularly.
The Amazon listing does not state the minimum or maximum lift height, so check those figures on the listing or with Hein-Werner before buying, and compare them with your own measurements. Expect a long, heavy jack that needs a dedicated spot on the floor. For an occasional tire swap on a compact crossover it is more jack than you need.
View Hein-Werner HW93667 on Amazon

5. Big RED 3-Ton Heavy Duty Floor Jack: Dual Pump Quick Lift, 5.12 to 18.31 in.

- 3 ton (6,600 lb listed) capacity
- Lift range of 5.12 to 18.31 in.
- Dual pump quick lift
- Hydraulic system meets ASME standards
This Big RED 3-Ton floor jack is the shortest reaching pick here, with a listed lift range of 5.12 to 18.31 inches. That is enough for many compact and subcompact crossovers, whose pinch welds sit closer to the ground than those on a mid-size SUV. On a taller model, measure carefully, because 18.31 inches may leave too little room for a stand.
A dual pump quick lift system raises the saddle faster than a single piston design, cutting the number of strokes before the jack meets the vehicle. The listing states that the hydraulic system meets ASME standards and includes a safety valve, along with a slow release for controlled lowering. The frame is heavy-duty steel.
Capacity is given as 3 tons, with the listing also quoting 6,600 lbs, and the listing names cars, SUVs, vans and trucks as suitable vehicles. A one-year warranty is included. If your household runs a compact crossover and a small car, this jack covers both, but owners of larger or lifted SUVs should look at the taller picks above, such as the Torin or American Lifting jacks.
View Big RED 3-Ton Heavy Duty on Amazon
Matching a Jack to Your SUV
Treat this table as a shortlist, not a fitment guarantee. Lift kits, larger tires and aftermarket skid plates all change the numbers, so your own tape measure still has the final word.
| Your SUV | What to look for | Jacks from this list |
|---|---|---|
| Compact crossover | 3 ton, low start, 18 in. or more at the top | Big RED 3-Ton, Omega 29038 |
| Mid-size two-row or three-row crossover | 3 to 3.5 ton, about 20 to 21 in. of reach | Torin 3 Ton, Omega 29038 |
| Tall or body-on-frame SUV | 22 in. or more of reach, wide saddle | American Lifting AL2301 |
| Heavy full-size SUV | 4 ton rating and a long chassis | Hein-Werner HW93667 |
If you own both a crossover and a sports car, one jack may not cover both. A tall service jack that clears a body-on-frame SUV will not slide under a car with a low splitter, which is why some households keep two.

Safe Lifting in a Cold, Salty Garage
The jack raises the SUV, and jack stands hold it there. Once the tire clears the floor, slide in a pair of stands rated for the vehicle, lower the weight onto them, and only then reach underneath. The OSHA standard for jacks is written for workplaces, yet its basics hold at home too: never exceed the rated load, use a firm base, and support the load right after lifting.
- Block what stays down: chock the wheels on the opposite end, set the parking brake and leave the shifter in park.
- Inspect the seam first: after a few Michigan winters, pinch welds and frame rails can carry scale and rust, so look before the saddle touches metal.
- Warm up the hydraulics: in an unheated garage the fluid thickens, so cycle the jack a few times before putting weight on it.
- Watch the slope: a slight driveway grade can make a heavy SUV roll toward or away from the jack as it rises.

Keep the jack itself in shape as well. Check for oil weeping around the ram, a handle that pumps without lifting, or a saddle that creeps down under load, and stop using it until it is repaired. Our article on the car jack setups BMW owners rely on goes deeper into jack pads for finished lift points.
When to Hand the SUV to a Shop
Even the best floor jack for SUVs, paired with good stands, only covers tire rotations, pad checks and fluid work in your own garage. Some SUV jobs ask for more. Coil springs and struts store a lot of force, and worn control arms or ball joints on a heavy SUV need presses and alignment equipment, which is where our suspension repair in Grand Rapids comes in.

If you would rather hand off the routine items, our factory scheduled maintenance in Grand Rapids follows the service intervals your SUV’s maker sets. For grinding or pulsing brakes, book brake repair at our Grand Rapids shop before you put more miles on them.
More Buying Guides
Frequently Asked Questions
Is a 3 ton floor jack enough for an SUV?
For most compact and mid-size SUVs it is, since the jack carries only one end or corner. Heavier full-size SUVs leave less margin, so a 3.5 or 4 ton jack is the more relaxed choice there.
How high should a floor jack lift for an SUV?
Measure your lift point, add the rise needed to clear the tire and a little room for a stand, and compare. Many mid-size and full-size SUVs call for about 20 inches or more of maximum height.
Where do I put a floor jack on a crossover?
Use the points in the jacking diagram of your owner’s manual, usually reinforced pinch welds near each wheel or a central front or rear point. A slotted rubber pad keeps the pinch weld from bending.
Can a low profile jack work on an SUV?
It can if its maximum height still reaches your lift point with room to spare. Several jacks start near 4 to 5 inches and top out around 21 inches, so low start and SUV reach are not always opposites.
Want your SUV on a full lift for suspension, brakes or scheduled service instead? Call 456 AutoFix at 616-279-3832, Monday to Friday 8am to 5pm, or send us a request on the contact page.
Working the same hours we do? Our after-hours drop-off lets you bring the SUV to 456 Carrier St NE, Grand Rapids, whenever your evening allows.
